Missing only one digital output for your project?
Need to pulse a device with 12 or 24V?
Convert any DDC 0-10V output into a normally open 24VAC or DC , 0.9A (1000ma (1A) peak) solid state relay.
This converter don't need any external power supply.
It uses less than 8ma from the analog output to turn on .
0-2.5V is Off 2.5 to 12V is ON ( numbers are approximation , can vary slightly depending on wire resistance and length)
Can be used to control small 24VAC actuator motors or relays.
Since there is no external power supply needed, it can be placed close to the controller or near the device to be controlled.
The small form factor mounted on rails makes it easy and practical for to use in control panels.
It can also be put into a shrink wrap to be used inline.
Best solution to pulse a device normally operated on 24VAC DATA11.75mm wide69.5mm long 18mm high( connector height)Input voltage: 2.5 to 12VDCCurrent input: 8maCurrent output : 0.9amp under 24VAC (peek max 1A 28VAC)Can be mounted in snap trackCan be shrink wrapped to be used inline also available with wires for lower profile use
One channel signal converter module.
For a signal change from 0..10Vdc (from external controller) into
an on/off relay contact output.